KIT_A2G_TC377TX_3V3_E_TR

KIT_A2G_TC377TX_3V3_E_TR

The new Automotive 10Base-T1S Ethernet kit from Infineon merges the innovations brought by the new 10Base-T1S specification with the powerful well-known multicore computing performance of the AURIX™ 2nd generation family. It enables the creation of multidrop topology networks using the same unshielded twisted pair while benefiting from the flexibility, scalability, integrated safety, and security support from AURIX™.

The Automotive 10Base-T1s Ethernet kit consists on 2 different parts

AURIX™ TC377TX Triboard with extended header

AURIX™ TC377TX Triboard features a 3/3 cores and 6MB Flash microcontroller and also includes an extended 2x20 Pin Header to connect the AddOn boards described below, providing a full MII interface, as well as SPI connection for MAC PHYs. Additionally, the board also provides a Gigabit Ethernet interface that could be used in parallel.

 Key features:

• AURIX™ TC377TX Controller, with 3/3 cores, 6MB Flash
• Gigabit Ethernet interface with PHY, supporting different Ethernet topologies
• Ready to use AddOn Board interface, with extended 2x20 Pin Header:
• Full MII interface for half duplex mode
• QSPI with 2 Chip Select signals
• 4 ADC channels
• Standard automotive interfaces (CAN, CAN-FD, FlexRay, LIN)
• AURIX™ Computing Performance, flexibility, scalability, integrated safety and security support

• Orderable in 2 different versions:
• With Microchip LAN8670 PHY 
• With Microchip LAN8651 MACPHY 
• 12 Pin MINI50 Molex connector allowing to build a bus topology
• Jumper to configure bus termination
• Switchable PoDL support (selectable as source or sink)

Product Table