KIT_A2G_TC377_SEC_GTW

Secure Gateway Board
Infineon has combined its wealth of experience in microcontroller design to create a new Automotive Secure Gateway evaluation board that can cover a broad range of automotive. Either for gateway, sensor fusion, or telematics systems, this new evaluation board is the ideal solution for bringing projects out of the paper, being the right environment for rapid prototyping while minimizing R&D efforts and time to market

AURIX™ – TC3xx family:

• AURIX™ TC377TX
• Up to 3 CPUs at 300 MHz
• Up to 6 MB internal Flash/4 MB internal SRAM
• 2x Gbit Ethernet QoS MAC with 8 Tx and 8 Rx DMA channel/queues
• Support of Ethernet standards IEEE 802.1AS-2011 and 802.1-Qav-2009, 802.1AS – IEEE 1588-2008
• A standby controller to support low power modes

Marvell 88Q5050 8-port Ethernet Switch:

• 4 fixed 100Base-T1 ports, 1 x 100Base-T1 and 1 x 1000BaseT1, one RGMII port to AURIX™
• Trusted Boot functionality
• Deep packet inspection (DPI)
• AEC-Q100 Grade 2 qualified
• Integrated ARM Cortex-M7 CPU, 250 MHz

Note: If Schematics and Marvel Documents are required this can only be shared with a valid Marvel NDA

Rosenberger H-MTD® connector:

• Modular and scalable connection system for automotive Ethernet
• High performance 100 Mbps and 1 Gbps according to IEEE 100Base-T1/1000Base-T1 with Standard 1000Base-T1 / 100Base-T1 quad-connector
  
  To order the cable:  see our webshop
  
  

AURIX™TC377 with two Gigabit Ethernet MACs:

• GETH MAC0 connected to 88Q5050, GETH MAC1 connected to 1000Base-T PHY
• 2 CAN-FD channel with different Infineon transceivers -TLE9250VSJ, TLE9252VSK, TLE9254VSK, TLE9255WSK
• 2 LIN channel -TLE7258SJ
• 2 Flexray channel -TLE9222PX

Infineon TPM SLB9670VQ2.0

eMMC

Infineon Supply IC :

• TLF30682QVS01, TLS4125D0EPV50, TLS203B0LDV, IR3883

Related application:

• Central car gateway
• New E/E car architectures Distributed, Domains and Zones

3D-Model of the Board

Peripheral Boards and connectors for this Kit:

GW Extension Flexray/LIN
• One Molex CAN cable
• One extension Board – 4 SUB-D9 female for Flexray, 5 pin header for LINs, pin header for extension signals

GW Extension CAN
• One Molex CAN cable
• One extension Board – 10 SUB-D9 male for CAN, pin header for measurements, Jumper to connect Nodes on a common bus

GW Base-T1 – Rosenberger Board Connector
Vector: SAP Part No.: 05133; Article Name: AEcable 2Y H-MTD Zjj

Link to Infinoen