KIT_A2G_TC337_5V_TRB_S

• Infineon's TC3X7 (TC397, TC387, TC377, TC367, TC337, TC327, TC3E7)1) AURIX^TM 2G Controller in LFBGA-292 Package
• FlexRay^{TM 2)} Transceivers
• High Speed CAN Transceivers (CAN-FD capable)
• USB to UART bridge
• Serial Eeprom
• LIN Transceiver
• Crystal 20MHz (default) or External Clock
• USB miniWiggler JDS for easy debugging
• 8 Low Power Status LEDs
• 8-DIP switches for configuration
• access to all pins of controller
• 100mm x 160mm (EURO-Board)

Connectors

The TC3X7 TriBoard offers a wide variety of connectors:

• Standard power connector
• Micro USB connector for ASC Interface (ASCO) and miniWiggler
• 16-pin header for JTAG interface (OCDS)
• 3 x 10-pin header for DAP, DAPE and DAP_SCR (DAPE only usable on Emulation Device)
• 10pin (2x5) Header for LIN Transceiver (LIN)
• 2 x lOpin (2x5) Header for CAN High Speed Transceiver (CANO and CAN1)
• 2 x lOpin (2x5) Header for FlexRay^TM (ERAY-A and ERAY-B)
• four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• optional ETK connector
• optional 2 x 6pin (IEEE1394) Socket for HSCT
• optional Aurora connector (only with Emulation Device)

Components

• Infineon's Multi Voltage Safety Micro Processor Supply TLF35584QV
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,25 Volt)
• LED indicating safe state signal 2 from TLF35584
• LED indicating /HDRST (ESRO) active state
• LED indicating activ miniWiggler JDS
• LED switched via DAS software
• 2x Infineon's FlexRay^TM Transceiver TLE9221SX
• 2 x Infineon's High Speed CAN-Transceiver TLE9251VSJ
• Infineon's LIN-Transceiver TLE7259-3GE
• USB to UART bridge FT2232HL (FTDI)
• 8 general purpose LEDs
• 2K I ²C Serial Eeprom with EUI-48^{TM 2)} Node Identity (MICROCHIP)
• Reset switch
• Enable switch
• Generic switch
• 4-pin Dip switch