KIT_A2G_TC366_5V_TRB_S

• Infineon's TC3X6 (TC366, TC336) AURIX^TM 2G Controller in LFBGA-180 Package
• FlexRay^{TM 1)} Transceivers
• High Speed CAN Transceivers (CAN-FD capable)
• USB to UART bridge
• Ethernet PHY
• Serial Eeprom
• LIN Transceiver
• Crystal 20MHz (default) or External Clock
• USB miniWiggler JDS for easy debugging
• 8 Low Power Status LEDs
• 8-DIP switches for configuration
• access to all pins of controller
• 100mm x 160mm (EURO-Board)

Connectors

The TC3X6 TriBoard offers a wide variety of connectors:

• Standard power connector
• Micro USB connector for ASC Interface (ASCO) and miniWiggler
• RJ45 connector for Ethernet
• 16-pin header for JTAG interface (OCDS)
• 2 x 10-pin header for DAP and DAP_SCR
• lOpin (2x5} Header for LIN Transceiver (LIN)
• 2 x lOpin (2x5) Header for CAN High Speed Transceiver (CANO and CAN1)
• 2 x 10pin (2x5) Header for FlexRay^TM (ERAY-A and ERAY-B)
• four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
• optional ETK connector
• optional 6pin (IEEE1394) Socket for HSCT

Components

• Infineon's Multi Voltage Safety Micro Processor Supply TLF35584QV
• Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,25 Volt)
• LED indicating safe state signal 2 from TLF35584
• LED indicating /HDRST (ESRO) active state
• LED indicating activ miniWiggler JDS
• LED switched via DAS software
• 2 x Infineon's FlexRay^TM Transceiver TLE9221SX
• 2 x Infineon's High Speed CAN-Transceiver TLE9251VSJ
• Infineon's LIN-Transceiver TLE7259-3GE
• USB to UART bridge FT2232HL (FTDI)
• Single-Chip/Port 10/100M Ethernet PHYCEIVER with Auto MDX RTL8201FI-VC-CG (Realtek)
• 8 general purpose LEDs
• 2K I²C Serial Eeprom with EUI-48^{TM 2)} Node Identity (MICROCHIP)
• Reset switch
• Enable switch
• Generic switch
• 4-pin Dip switch