zzgl. MwSt. zzgl. Versandkosten
Sofort versandfertig, Lieferzeit ca. 1-3 Werktage
- Artikel-Nr.: 37.96.0204.0
- Freitextfeld 2: SP000911130
MCU Derivates: SAK-TC1724-192F133HL
CPU Clock: 133 MHz
Including:
- TriBoard Hardware
- USB cable
- Power Supply
- Extension Board
- Free TriCore Entry Tool Chain
- Getting Started, first 3 Steps to
Install the Tools
Set up your Hardware
Write and debug your first Program
On-Chip Memory:
- 1,5 MByte embedded program flash with ECC
- 64 KByte data Flash
- 152 KByte on-chip SRAM,
- 4 KByte data cache (configurable)
- 8 KByte instruction cache (configurable)
Interfaces:
>One USB connector for ASC0 Interface via virtual COM port, JTAG (OCDS Level1)
16-pin header for JTAG interface (OCDS Level 1)
10-pin header for DAB
2 x 10pin (2x5) header for CAN High Speed Transceiver (CAN0 and CAN1)
2 x SUB-D9 Plug connector for FlexRay
Four 80-pin connectors (male) + four 80-pin connectors (female) with all I/O signals
ETK connector (optional)
Components:
>Infineon’s Next generation micro controller supply TLE 7368 G
2 x Infineon’s High Speed CAN-Transceiver TLE 6250 GV33
USB to UART bridge FT2232D (FTDI)
SPI EEPROM (Atmel)
2 x FlexRay Transceiver AS2821(AMS) or TJA1080 (NXP)
Three LEDs to validate power supply (5Volt / 3,3 Volt / 1,5 Volt)
LED indicating /HDRST (ESR0) active state
LED indicating active miniWiggler
LED switched via DAS software
8 general purpose LEDs
Reset switch
8-pin Dip switch (Hardware Boot Configuration)
Find more information about the Starter Kit TC1724 at the Infineon Website.